Re: programming an Ademco Vista

[rickm@xxxxxxxxxxxxxx]

On Apr 27, 9:31=A0pm, "Mark Leuck" <mle...@xxxxxxxxx> wrote:
> <ri...@xxxxxxxxxxxxxx> wrote in message
>
> news:c9e35072-864d-4f01-9575-b5096ae207ec@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> On Apr 27, 1:56 pm, "Doug" <n...@xxxxxxxx> wrote:
>
>
>
>
>
> > <ri...@xxxxxxxxxxxxxx> wrote in message
>
> >news:2a80aa44-b9c7-45f6-8c40-1617aff96b0a@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx=

> > On Apr 27, 12:54 pm, "alarman" <nos...@xxxxxxxx> wrote:
>
> > > ri...@xxxxxxxxxxxxxx wrote:
> > > >The IR motion is not working
> > > > though. Ive tried NO ever mode and it fails the walk test. The other=

> > > > zones report a fault and chime but the IR doesnt report
> > > > anything. I enabled the sensor's LED and its getting power and
> > > > "see's" movement. I have it set to TYPE4 and NC which
> > > > allows the system to come READY. I have the inline resister on the
> > > > LO side on the panel.
>
> > > I you arm the system but don't open an entry/exit door, the system may=

> > > bypass the motion detectors, thinking you are still inside.
>
> > > --
> > > js
>
> > > He who laughs last.......thinks the slowest
>
> > Interesting point, how can the motion be tested?
>
> > If you have programmed the zones for EOL resistors then make sure you ar=
e
> > using the correct value EOLs.
> > If you have programmed the zones for NC then make sure you aren't using
> > EOL
> > resisotrs.
> > Make sure all zones show normal on the keypad.
> > Turn the alarm on
> > Open and close an entry/exit door.
> > Wait for the exit delay to expire and then walk past the motion sensor
> > Listen for the siren/bell or whatever audible device you have connected.=

>
> > Doug- Hide quoted text -
>
> > - Show quoted text -
>
> Looks like are 2 issues, the first is that auto-stay was enable so
> thats been fixed. =A0The IR needs to be
> set to NC for the system to ready. =A0I removed the series resistor and
> and set it to TYPE10. =A0The IR still
> does not trip the alarm. =A0I metered the HI/LO terminals and it always
> read about 13.4VAC whether the
> sensors beams where broken or not as indicated by the LED. =A0I would
> expect it the voltage to drop to
> about 3VAC like the door switches.
>
> =A0 Im thinking the IR is broken! =A0 =A0 ...anyone agree???
>
> I think the installer is broken- Hide quoted text -
>
> - Show quoted text -

why?