RE: New lighting wiring

["Richard" <rich_lists@xxxxxxxxxx>]

Transformer based should be ok because the transformer should eat the
leakage current.



The problem are the 230 volt leds because they have a series capacitor to
drop the voltage so overheat on anything with harmonics.



From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Marcus Warrington
Sent: Thursday, January 24, 2008 11:21 PM
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] New lighting wiring



Ahh yes, forgot about the *minimum* load requirements of an LD11. :-(

Marcus

________________________________

From: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
[mailto:ukha_d@xxxxxxx
<mailto:ukha_d%40yahoogroups.com>
] On Behalf
Of Neil Ball
Sent: 21 January 2008 17:23
To: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
Subject: RE: [ukha_d] New lighting wiring

That *may* be ok as the overheating problems/catastrophic failures were
to
do with CFL lamps not LEDs. That said there could be problems if the LED
load is below the minimum load of the dimmer - I've seen LEDs flashing
on/off when the dimmer was supposedly in the off state - was a Lutron
leading edge dimmer from their Homeworks system though so an X10 dimmer
may
have a different effect.

Neil B.

_____

From: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
<mailto:ukha_d%40yahoogroups.com>
[mailto:ukha_d@xxxxxxx
<mailto:ukha_d%40yahoogroups.com>
<mailto:ukha_d%40yahoogroups.com>
] On
Behalf Of
Marcus Warrington
Sent: 21 January 2008 15:29
To: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
<mailto:ukha_d%40yahoogroups.com>
Subject: RE: [ukha_d] New lighting wiring

Ho Hum... I guess my plan to use an LD11, toggled 0% to 100% (by
Homevision) , as a quite relay to turn on some 12v LED bathroom lighting
(running on a 240v transformer) probably isn't a good idea then.

Marcus

__________

[Non-text portions of this message have been removed]

[Non-text portions of this message have been removed]





[Non-text portions of this message have been removed]