The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]

RE: New lighting wiring



That *may* be ok as the overheating problems/catastrophic failures
were to
do with CFL lamps not LEDs. That said there could be problems if the LED
load is below the minimum load of the dimmer - I've seen LEDs flashing
on/off when the dimmer was supposedly in the off state - was a Lutron
leading edge dimmer from their Homeworks system though so an X10 dimmer may
have a different effect.



Neil B.





_____

From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf Of
Marcus Warrington
Sent: 21 January 2008 15:29
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] New lighting wiring



Ho Hum... I guess my plan to use an LD11, toggled 0% to 100% (by
Homevision) , as a quite relay to turn on some 12v LED bathroom lighting
(running on a 240v transformer) probably isn't a good idea then.

Marcus

__________



[Non-text portions of this message have been removed]




UKHA_D Main Index | UKHA_D Thread Index | UKHA_D Home | Archives Home

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.