[Message Prev][Message
Next][Thread Prev][Thread Next][Message
Index][Thread Index]
RE: New lighting wiring
Ahh yes, forgot about the *minimum* load requirements of an LD11. :-(
Marcus
________________________________
From: ukha_d@xxxxxxx [mailto:ukha_d@xxxxxxx] On Behalf
Of Neil Ball
Sent: 21 January 2008 17:23
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] New lighting wiring
That *may* be ok as the overheating problems/catastrophic failures were
to
do with CFL lamps not LEDs. That said there could be problems if the LED
load is below the minimum load of the dimmer - I've seen LEDs flashing
on/off when the dimmer was supposedly in the off state - was a Lutron
leading edge dimmer from their Homeworks system though so an X10 dimmer
may
have a different effect.
Neil B.
_____
From: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
[mailto:ukha_d@xxxxxxx
<mailto:ukha_d%40yahoogroups.com>
] On
Behalf Of
Marcus Warrington
Sent: 21 January 2008 15:29
To: ukha_d@xxxxxxx <mailto:ukha_d%40yahoogroups.com>
Subject: RE: [ukha_d] New lighting wiring
Ho Hum... I guess my plan to use an LD11, toggled 0% to 100% (by
Homevision) , as a quite relay to turn on some 12v LED bathroom lighting
(running on a 240v transformer) probably isn't a good idea then.
Marcus
__________
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
UKHA_D Main Index |
UKHA_D Thread Index |
UKHA_D Home |
Archives Home
|