Re: RR501 receives the rf signal, but won't send to other units

[nobody@xxxxxxxxxxxx (Dave Houston)]

Ahhh! Why didn't you say so in the first place? ;)

If the table top controller works in the same outlet, you've ruled out a
signal sucking appliance.

It appears that your RR501 has indeed gone bad. The RF receiver section is
probably OK since you can control the relay with it but the PLC transmitter
section (which sends to the powerline) is kaput.

Just out of curiosity, try controlling the relay by sending with the table
top controller.

neergqj@xxxxxxxxx wrote:

>That's what I did.  After I concluded that the RR501 was receiving the
>RF signal (as evidenced by the click when unit code 9 was sent), but
>that the X-10 signal wasn't going anywhere (as evidenced by units
>1,2,3,4 or 9 not responding) I unplugged the %%501 and plugged in the
>table top transmitter to the same outlet. Viola! X-10 response.
>
>Any further thoughts?