Re: DSC 832 on Cable VoIP

[mleuck <m.leuck@xxxxxxxxx>]

On Jan 7, 8:29=A0pm, tourman <robercampb...@xxxxxxxxx> wrote:
> On Jan 4, 7:55=A0pm, Frank Olson
>
>
>
> <use_the_email_li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
> > tourman wrote:
> > > On Jan 4, 12:14 pm, "Robert L Bass" <nore...@xxxxxxxxxxxxxx> wrote:
> > >> "tourman" wrote:
>
> > >>> RHC: Yes, I can see the panel trying the number of times it's set t=
o
> > >> call and continue to retry until it either gets through or generates=
 a
> > >> "failure to communicate" trouble. However, this panel is simply not
> > >> even trying tro call depending upon what set of signals it is suppos=
ed
> > >> to send. Manual test, excludes the line, and goes through perfectly.
> > >> Keypad alarms and regular alarms and restores....it doesn't even pic=
k
> > >> up the line and try =A0????
>
> > >> Bob,
>
> > >> This doesn't sound like a VoIP issue. =A0It really seems as though s=
omething else
> > >> is set wrong in the programming.
>
> > >> --
>
> > >> Regards,
> > >> Robert L Bass
>
> > >> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D=3D=3D=3D>
> > >> Bass Home Electronics
> > >> DIY Alarm and Home Automation Storehttp://www.bassburglaralarms.com
> > >> Sales & Service 941-870-2310
> > >> Fax 941-870-3252
> > >> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D=3D=3D=3D>
>
> > > To Jim and Bob...yes, that was my first guess; however, I've checked
> > > all the programming and everything is perfect. Perhaps a default woul=
d
> > > help; DSC products are funny that way...solves lots of problems not
> > > solvable any other way for some reason....
>
> > Also try reversing the tip and ring (t-1 and r-1 too).
>
> RHC: UPDATE.....after attaching my laptop to the panel on prem, and
> uploading it, I quickly saw that "Partition 1 was disabled and
> Partition 2 was enabled. So the panel wasn't even seeing the existing
> zones.
>
> Damn....major stupid mistake...egg on my face. Moral of this
> story...always upload your panels rather than depend upon keypad
> programming, and when approaching any problem, check the simple things
> first...
>
> Now I kinda wish I hadn't started this thread, so wouldn't have to eat
> crow.....:))

Remember this the next time you slam ADT for programming/installation
errors