Re: eol dsc1550

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

you should read the output of the charging circuit without the battery, not
sure what it should be on a DSC you'd have to call tech support if they
still have tech support any more.


--
**Crash Gordon**







"joe" <klcross@xxxxxxxxxxx> wrote in message
news:MoudnXqOvP4WYWnanZ2dnUVZ_o6knZ2d@xxxxxxxxxxxxxx
| Crash Gordon wrote:
| > ot: you guys are not up in vegas I guess?
| >
| >
| >
| I'm not up in Vegas but who is?
|
| I made all zones, 1, 3 which is slow &
| silent and Interior Home-Away Loop.
| With no fire zone. Then I made all zones
| normally closed without a end of line
| resistor. This works fine, all zones are
|  off, and the ready light is on the
| keypad.
|
| The trouble light is coming on now after
| a few minutes, which points to the battery.
|
| I am going to give it a few hours then
| go back and check to see if the battery
| trouble light remains on.
|
| I had to come back to this newsgroup and
| read about what the board should be
| putting out for the battery. The Battery
| is new. If when I go back and the
| trouble light is still on. The float
| charges is around what 13.4 to 13.8. I
| will just put a meter to the plus and
| minus sides of the battery wires, to
| check this. Would this be correct? I
| want to see if the board is charging the
| battery.
|
| Thanks, Joe
|
| PS I've only been to Vegas once, that
| was when I was younger, and now I have
| more bills to pay.