Re: Moose Z1100 Dialing Problem

["Mark Leuck" <m..leuck@xxxxxxxxx>]

It was always easier for me to use an LED keypad than the Alpha, DSC panels
are like that as well

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:46b7f9be$0$10298$815e3792@xxxxxxxxxxxxxxxxx
> aggggg...you're using an LED keypad to program that beast?!
>
> what happened to your alarm guy?...he give up and go home?
>
> :-)
>
>
>
> --
>
> Rob Giordano
> Microsoft MVP - FrontPage
>
>
>
>
>
> "mmar via HomeKB.com" <u36358@uwe> wrote in message
> news:76516df4cdd39@xxxxxx
> |I figured out how to read back what was programmed. (Close the
> | programming switch, hit 0 after power up, then a 3-digit address.
> | From there, hit pound and it will sequence through the addresses.
> | The 8 LEDs give the programmed value in binary as the manual
> | describes.)  It appears that there are no telephone numbers
> | programmed, and it is just picking up and doing nothing. I did not
> | have a chance to reprogram, but I did read all the values and will
> | try to do a factory reset and then reprogram. I need to do the reset
> | because the programming code was overwritten somewhere along the path.
> |
> | Thanks for the help.
> |
> | Jim wrote:
> | >
> | >Well, the zones could be programed to report on alarm but the panel
> | >isn't programmed with a telephone number or account number.
> | >
> | >It would pick up and do nothing.
> |
> | --
> | Message posted via HomeKB.com
> | http://www.homekb.com/Uwe/Forums.aspx/security-alarms/200708/1
> |
>
>