Re: Moose Z1100 Dialing Problem

["mmar via HomeKB.com" <u36358@uwe>]

The alarm company tech did put the butt set on the tip and ring
but we did not do the factory reset. We did get the dial tone, then
got no sound, but no dial and no connect. The tech did manually
dial the number and got an answer, but the z1100 did not handshake.

If I do the reset, I will lose the phone numbers and will need to get
them from the tech, which will be later in the week. You had said
it won't call a cell phone, which is ok. But can I program in some
number to see if it is dialing?

Thanks.

Buggs wrote:
>> Thanks for the response!
>>
>[quoted text clipped - 13 lines]
>>> section 068. No, it won't call your cell phone.
>>> js
>
>Try programming 255 into section 009. this will reset the panel to factory
>programming. Then start over from scratch. Connect a butt set to the tip and
>ring terminals and listen to what happens. Do you get a dial tone? Is the
>panel dialing a number? Is there a handshake from the receiver? What happens
>exactly.
>js

--
Message posted via http://www.homekb.com