Re: Moose Z1100 Dialing Problem

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

aggggg...you're using an LED keypad to program that beast?!

what happened to your alarm guy?...he give up and go home?

:-)



--

Rob Giordano
Microsoft MVP - FrontPage





"mmar via HomeKB.com" <u36358@uwe> wrote in message
news:76516df4cdd39@xxxxxx
|I figured out how to read back what was programmed. (Close the
| programming switch, hit 0 after power up, then a 3-digit address.
| From there, hit pound and it will sequence through the addresses.
| The 8 LEDs give the programmed value in binary as the manual
| describes.)  It appears that there are no telephone numbers
| programmed, and it is just picking up and doing nothing. I did not
| have a chance to reprogram, but I did read all the values and will
| try to do a factory reset and then reprogram. I need to do the reset
| because the programming code was overwritten somewhere along the path.
|
| Thanks for the help.
|
| Jim wrote:
| >
| >Well, the zones could be programed to report on alarm but the panel
| >isn't programmed with a telephone number or account number.
| >
| >It would pick up and do nothing.
|
| --
| Message posted via HomeKB.com
| http://www.homekb.com/Uwe/Forums.aspx/security-alarms/200708/1
|