Re: ADT Focus 32

["R.H.Campbell" <rh.campbell@xxxxxxxxxxxxx>]

I'm using SIA so there shouldn't be a problem then. Thanks for the update.

It's kind of unfortunate since this client is a great many miles from home.
If he needs any software changes, it's a visit or walk him through it at the
keypad.

Note to Mark...any idea where to get the ADT software drivers...

RHC

"Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
news:3Ht8g.8985$k%2.3780@xxxxxxxxxxx
> You should be ok. The only thing I see different sometimes is that ADT has
> its own variations of CID codes for certain types of signals.
>
> Jim Rojas
>
>
> "R.H.Campbell" <rh.campbell@xxxxxxxxxxxxx> wrote in message
> news:Vit8g.4911$aq5.225221@xxxxxxxxxxxxxxxxxxxxxxxx
>> Ah ha ! Thanks Jim. Next time I'm out that way, I'll look at the board
>> again to see if it's their "proprietary" (more like semi proprietary...)
>> model. I didn't know that....
>>
>> I used the standard DSC 5010 vers 2.0 programming sheets to program it.
>> Hope that was OK. If not, maybe I should go change out the
>> board...whatdaya think ?
>>
>> RHC
>>
>> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
>> news:DAs8g.547$Lh.491@xxxxxxxxxxx
>>> If the small white label beneath the firmware chip states
>>> PC5010ADT...you won't be able to use the DLS2002, unless you have the
>>> patch installed. Sometimes ADT or their authorized dealers use off the
>>> shelf boards on service calls, or if the run out of stock. This is why
>>> you were probably able to get into some in the past.
>>>
>>> Jim Rojas
>>>
>>>
>>> "R.H.Campbell" <rh.campbell@xxxxxxxxxxxxx> wrote in message
>>> news:kvq8g.4843$aq5.217630@xxxxxxxxxxxxxxxxxxxxxxxx
>>>> After taking over a Power 832 from ADT the other night, as per usual,
>>>> the next day I tried to dial in to check my settings. No matter how
>>>> many times I connect (using auto detect or otherwise), the software
>>>> tells me it cannot identify the panel.
>>>>
>>>> I seem to remember dialing in to Focus 82 private labelled panels
>>>> before with no trouble, but this one can't be recognized by the
>>>> software (latest version with all drivers). The client is way out in
>>>> the country and has a very noisy telephone line, so might that be the
>>>> reason why ?
>>>>
>>>> Anyone had this experience before ?
>>>>
>>>> RHC
>>>>
>>>
>>>
>>
>>
>
>