Re: ADT Focus 32

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

You should be ok. The only thing I see different sometimes is that ADT has
its own variations of CID codes for certain types of signals.

Jim Rojas


"R.H.Campbell" <rh.campbell@xxxxxxxxxxxxx> wrote in message
news:Vit8g.4911$aq5.225221@xxxxxxxxxxxxxxxxxxxxxxxx
> Ah ha ! Thanks Jim. Next time I'm out that way, I'll look at the board
> again to see if it's their "proprietary" (more like semi proprietary...)
> model. I didn't know that....
>
> I used the standard DSC 5010 vers 2.0 programming sheets to program it.
> Hope that was OK. If not, maybe I should go change out the
> board...whatdaya think ?
>
> RHC
>
> "Jim Rojas" <jrojas@xxxxxxxxxxxx> wrote in message
> news:DAs8g.547$Lh.491@xxxxxxxxxxx
>> If the small white label beneath the firmware chip states PC5010ADT...you
>> won't be able to use the DLS2002, unless you have the patch installed.
>> Sometimes ADT or their authorized dealers use off the shelf boards on
>> service calls, or if the run out of stock. This is why you were probably
>> able to get into some in the past.
>>
>> Jim Rojas
>>
>>
>> "R.H.Campbell" <rh.campbell@xxxxxxxxxxxxx> wrote in message
>> news:kvq8g.4843$aq5.217630@xxxxxxxxxxxxxxxxxxxxxxxx
>>> After taking over a Power 832 from ADT the other night, as per usual,
>>> the next day I tried to dial in to check my settings. No matter how many
>>> times I connect (using auto detect or otherwise), the software tells me
>>> it cannot identify the panel.
>>>
>>> I seem to remember dialing in to Focus 82 private labelled panels before
>>> with no trouble, but this one can't be recognized by the software
>>> (latest version with all drivers). The client is way out in the country
>>> and has a very noisy telephone line, so might that be the reason why ?
>>>
>>> Anyone had this experience before ?
>>>
>>> RHC
>>>
>>
>>
>
>