Re: Low Battery FBII-2P (( Rep to G Morgan))

[G. Morgan <sealteam6@xxxxxxxxxxxxxxxxx>]

Jim Wrote:

>The only other thing I can think of is a ground fault (or partial ground fault) on the keypad wire run which could be proved if you connected the keypad directly to the panel. Actually, a ground fault with the right amount of resistance on any power run could be the cause. Just enough to draw the battery down but not enough to blow the fuse.
>
>Have you tried to disconnect all wiring, short out the zones, wire the keypad direct, disconnect the bell and see what happens?
>
>(You may have tried this, sorry if I missed it)


Yeah, that's what I was getting at by ohm'ing out the cable and seeing if
it's the culprit.


--

They who can give up essential liberty to obtain a little temporary safety,
 deserve neither liberty nor safety. - Ben Franklin