Re: Safewatch Pro 3000 arm/disam status

[Gadgets <bcburn@xxxxxxxxx>]

On Mar 10, 9:58 am, Frank Olson
<use_the_email_li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
> Roland Moore wrote:
> > I don't know that that a Pro3000 is a Vista 20P. But if it is a Vista 20P it
> > should be easy to do with a Ademco 4204.
> > Program 20P for using the 4204 the relay(s) for trigger type 2 and zone type
> > 20, 21 or 22 and device action of 2 or 4 and the respective device (relay)
> > number. That is all depending on exactly what relay you wish to use and the
> > relay action you want it to be. You will have to have a keypad like a 6160
> > or use Compass software (not available to anyone but ADT for ADT brand
> > panels). Programming relays on any Ademco panel can be a bit "funny". Many
> > times there are several ways to program the relays to get the same end
> > result.
>
> > From the instructions:
>
> <snip>
>
> He doesn't need a 4204.  He can use the onboard trigger output to fire a
> 12 volt relay (which would be cheaper than buying the 4204 or the 4229
> zone expansion module).  If he already has the 4229 zone expander, it
> comes with relays on board.
>
> The point is he obviously doesn't know how to program the unit (or
> doesn't have the manual).  He hasn't given us enough information about
> his setup.

If you knew how to do this Frank (which obviously you do not) you
would be offer then information I was looking for like Roland has.

 I have the manual, I have a 4204 and a 4229, I also have the required
keypad (if memory serves it's the 6160voice LCD keypad) I also have
the compass software, which by the way out of all the downloading
software I have used over the years.. is the worst, but that's not at
issue. Why do people like yourself bother responding if you are unable
to help??