Re: Safewatch Pro 3000 arm/disam status

["alarman" <nospam@xxxxxxxx>]

Gadgets wrote:
> On Mar 10, 9:58 am, Frank Olson
> <use_the_email_li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
>> Roland Moore wrote:
>>> I don't know that that a Pro3000 is a Vista 20P. But if it is a
>>> Vista 20P it should be easy to do with a Ademco 4204.
>>> Program 20P for using the 4204 the relay(s) for trigger type 2 and
>>> zone type 20, 21 or 22 and device action of 2 or 4 and the
>>> respective device (relay) number. That is all depending on exactly
>>> what relay you wish to use and the relay action you want it to be.
>>> You will have to have a keypad like a 6160 or use Compass software
>>> (not available to anyone but ADT for ADT brand panels). Programming
>>> relays on any Ademco panel can be a bit "funny". Many times there
>>> are several ways to program the relays to get the same end result.
>>
>>> From the instructions:
>>
>> <snip>
>>
>> He doesn't need a 4204.  He can use the onboard trigger output to
>> fire a 12 volt relay (which would be cheaper than buying the 4204 or
>> the 4229 zone expansion module).  If he already has the 4229 zone
>> expander, it comes with relays on board.
>>
>> The point is he obviously doesn't know how to program the unit (or
>> doesn't have the manual).  He hasn't given us enough information
>> about his setup.
>
> If you knew how to do this Frank (which obviously you do not) you
> would be offer then information I was looking for like Roland has.
>
> I have the manual, I have a 4204 and a 4229, I also have the required
> keypad (if memory serves it's the 6160voice LCD keypad) I also have
> the compass software, which by the way out of all the downloading
> software I have used over the years.. is the worst, but that's not at
> issue. Why do people like yourself bother responding if you are unable
> to help??

You're a computer guy...right?
No? Software "engineer"?
Network "engineer"

Yeah. Buzz the fuck off.

--
js

- There aint no rules in a knife fight, Butch.