Re: Can't address pull stationsight 5808 on Silent Knight panel.

[Frank Olson <use_the_email_links@xxxxxxxxxxxxxxxxxxxxxx>]

paul@xxxxxxxxxxxxx wrote:
> On Mar 21, 2:55 pm, Frank Olson
> <use_the_email_li...@xxxxxxxxxxxxxxxxxxxxxx> wrote:
>> p...@xxxxxxxxxxxxx wrote:
>>> On Mar 21, 1:41 pm, "p...@xxxxxxxxxxxxx" <p...@xxxxxxxxxxxxx> wrote:
>>>> Can't address pull stationsight 5808 on silent Knight panel.
>>>> Boy, am I frustrated!!..    Manual says just hook unit to 2 terminals
>>>> named SLC program,  follow menu instructions and the unit is
>>>> programmed.  I keep getting "connecting to device" but it never does!!
>>>> What am I doing wrong?
>>>> I have the correct +on SLC on panel and SLC on Unit.
>>>> I have the pull station address set for 1.
>>>> Any suggestions for what I can do?
>>>> PS  Silent Knight tech support closed for Easter today.   Thanks
>>> Model number of pull station is SD 500 Ps
>>> This is a new panel. I am tryiny to set 1 pullstation to address 1.
>>> I have verified correct polarity
>>> The panel has 3 sets of SLC terminals.
>>> ...SLC in  (I am not using)
>>> ...SLC out (I am not using at this time.  Manual sys to connect to SLC
>>> Program to address)
>>> ...SLC Program.  IO am using these terminals
>>>    Side Note: I do not have voltage at SLC Program terminals but I do
>>> have voltage on SLC Progam terminals
>> Connect the pull station to the SLC "out" terminals.  Observe proper
>> polarity.  You won't have a problem.- Hide quoted text -
>>
>> - Show quoted text -
>
> Sorry Frank, that doesn's work either.
>
> All I need to do is set the address on 16 smoke detectors SD 505 APs
> And 13 Pullstations SD 500 Ps.
> Manual says connect to SLC Program terminals and follow menu to set
> address.
> Keeps saying " No device found "  when I try to read it or
> "Connecting" when I try to write it.
> I have wasted all day on this problem.  AAAAAAAA!!!!!!!!!!!


Any way for you to send me the manual?