Re: Can't address pull stationsight 5808 on Silent Knight panel.

["paul@xxxxxxxxxxxxx" <paul@xxxxxxxxxxxxx>]

On Mar 21, 1:41=A0pm, "p...@xxxxxxxxxxxxx" <p...@xxxxxxxxxxxxx> wrote:
> Can't address pull stationsight 5808 on silent Knight panel.
>
> Boy, am I frustrated!!.. =A0 =A0Manual says just hook unit to 2 terminals
> named SLC program, =A0follow menu instructions and the unit is
> programmed. =A0I keep getting "connecting to device" but it never does!!
>
> What am I doing wrong?
>
> I have the correct +on SLC on panel and SLC on Unit.
> I have the pull station address set for 1.
>
> Any suggestions for what I can do?
>
> PS =A0Silent Knight tech support closed for Easter today. =A0 Thanks

Model number of pull station is SD 500 Ps
This is a new panel. I am tryiny to set 1 pullstation to address 1.
I have verified correct polarity
The panel has 3 sets of SLC terminals.
=2E..SLC in  (I am not using)
=2E..SLC out (I am not using at this time.  Manual sys to connect to SLC
Program to address)
=2E..SLC Program.  IO am using these terminals
   Side Note: I do not have voltage at SLC Program terminals but I do
have voltage on SLC Progam terminals