Re: DSC 864 with 5500Z keypads

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

True but he's talking about the buttons

"J Barnes" <trishnjames@xxxxxxxxxxx> wrote in message
news:heKdnQtJQ8RMI4HZRVn-tA@xxxxxxxxxxxxxx
> if you didnt have a keypad in slot 8,  the labels would not be
programmable
> from the downloader either. :(
>
> James
>
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:TsSdnVDzn-1iCoHZRVn-qg@xxxxxxxxxxxxxx
> > You have to go into programming on each keypad and set that in location
> > 000
> >
> > <cel@xxxxxxxxxx> wrote in message
> > news:M5CdnURbpJDRw4HZnZ2dnUVZ_vSdnZ2d@xxxxxxxxxxxxxx
> >> Yes they are enrolled, slot 6,7,8. I believe only #8 is getting the key
> >> assignments. It is strange that they all get the zone label downloaded
> >> OK.
> >>
> >> cel
> >>
> >> "Devin" <youdontneedit@xxxxxxxxxxxxx> wrote in message
> >> news:OnWSf.54$I13.18@xxxxxxxxxxxxxxx
> >> > cel@xxxxxxxxxx wrote:
> >> > > I have used the DSC windows software to program the keypad buttons,
> >> > > to
> >> stay,
> >> > > away, chime, reset, and exit. These work fine on one of the
keypads,
> > but
> >> on
> >> > > the other 2 keypads the buttons do other things. Do these buttons
> >> > > have
> >> to be
> >> > > programmed on the keypads themselves? I was hoping that any setting
I
> >> would
> >> > > do with the software would get sent to all of the keypads on the
> > system.
> >> > >
> >> > > cel
> >> > >
> >> > >
> >> > Each keypad has its own address, If i remember right section 000 has
a
> >> > subsection for each keypad.
> >>
> >>
> >
> >
>
>