Re: DSC 864 with 5500Z keypads

["J Barnes" <trishnjames@xxxxxxxxxxx>]

if you didnt have a keypad in slot 8,  the labels would not be programmable
from the downloader either. :(

James

"Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
news:TsSdnVDzn-1iCoHZRVn-qg@xxxxxxxxxxxxxx
> You have to go into programming on each keypad and set that in location
> 000
>
> <cel@xxxxxxxxxx> wrote in message
> news:M5CdnURbpJDRw4HZnZ2dnUVZ_vSdnZ2d@xxxxxxxxxxxxxx
>> Yes they are enrolled, slot 6,7,8. I believe only #8 is getting the key
>> assignments. It is strange that they all get the zone label downloaded
>> OK.
>>
>> cel
>>
>> "Devin" <youdontneedit@xxxxxxxxxxxxx> wrote in message
>> news:OnWSf.54$I13.18@xxxxxxxxxxxxxxx
>> > cel@xxxxxxxxxx wrote:
>> > > I have used the DSC windows software to program the keypad buttons,
>> > > to
>> stay,
>> > > away, chime, reset, and exit. These work fine on one of the keypads,
> but
>> on
>> > > the other 2 keypads the buttons do other things. Do these buttons
>> > > have
>> to be
>> > > programmed on the keypads themselves? I was hoping that any setting I
>> would
>> > > do with the software would get sent to all of the keypads on the
> system.
>> > >
>> > > cel
>> > >
>> > >
>> > Each keypad has its own address, If i remember right section 000 has a
>> > subsection for each keypad.
>>
>>
>
>