Re: DSC 864 with 5500Z keypads

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

You have to go into programming on each keypad and set that in location 000

<cel@xxxxxxxxxx> wrote in message
news:M5CdnURbpJDRw4HZnZ2dnUVZ_vSdnZ2d@xxxxxxxxxxxxxx
> Yes they are enrolled, slot 6,7,8. I believe only #8 is getting the key
> assignments. It is strange that they all get the zone label downloaded OK.
>
> cel
>
> "Devin" <youdontneedit@xxxxxxxxxxxxx> wrote in message
> news:OnWSf.54$I13.18@xxxxxxxxxxxxxxx
> > cel@xxxxxxxxxx wrote:
> > > I have used the DSC windows software to program the keypad buttons, to
> stay,
> > > away, chime, reset, and exit. These work fine on one of the keypads,
but
> on
> > > the other 2 keypads the buttons do other things. Do these buttons have
> to be
> > > programmed on the keypads themselves? I was hoping that any setting I
> would
> > > do with the software would get sent to all of the keypads on the
system.
> > >
> > > cel
> > >
> > >
> > Each keypad has its own address, If i remember right section 000 has a
> > subsection for each keypad.
>
>