Re: DSC-Cross Zone Police Code Alarm PROBLEM

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

Cross Zone trouble report code seems to be a 378 in the SIA CID table
however I don't think the 832 will properly report it

"Doug L" <vssdoug@xxxxxxx> wrote in message
news:ewzmg.5769$6w.3315@xxxxxxxxxxxxx
> Assuming that you have contact ID programmmed in both locations in 360,
you
> have 361 option 1 as on ,that you don't have the system partitioned and
you
> don't have transmission delay enabled in the zone attributes, then I would
> try changing section 363 option 1 and 368 option 1 to on, if that doesn't
> help then you could try  another code in section 328 instead of 4A such as
> 33 just to see if the CS is mishandling 4A
>
> Doug L
>
> --
>
> <oldmantrying@xxxxxxxxxxx> wrote in message
> news:k7al929n39tfr5krfj2p89pf05hprk3639@xxxxxxxxxx
> > Maybe some of your feedback may be referring to later VERSIONS of the
> > DSC 832 than I have. I have an installation manual & programming
> > worksheets booklet that are VERSION 2.0. I assume, perhaps
> > incorrectly, that I have a Version 2.0 board. Board was purchased NEW.
> >
> > The only place I can program  for Cross Zone is [328] Miscellaneous
> > Alarm Reporting Codes. I do not see any opportunity to program
> > anything about which ZONES or TIME between violations that constitute
> > cross zone. I have read in later Versions' manuals ( V 3.0 I think)
> > that you can program times and perhaps other options.
> > For [101]-[132] I only have 8 options per zone.
> >
> > Maybe there is a  parameter that I have programmed incorrectly.
> >
> > Here are the ones that MIGHT possibly effect cross zone and my
> > programming of these. I think all the parameters associated with cross
> > zone are programmed correctly because the central station gets
> > everything ELSE correctly.
> >
> > [328] option 4 & 5 = FF,OPTION 6 of course= 4A
> > [001]-[004] Doors=01, Windows=03, Some motions are=06, most are 05
> > [320]-[327] doors=34,windows=31, motions=32
> > [330]-[338]=FF
> > [339]-[348] all except Duress are FF
> > [349]-[351] all FF (If I am not home nobody to fix anything)
> > [352]-353]=FF
> > [360] option 1=on, others=OFF
> > [362]-[364]=off
> > [365] option 1=on, rest=off
> > [366]=all off
> > [367] option 1=ON, rest=off
> > [367] option 1=on, rest off
> > [368]= OFF
> > [370] 003,003,003,000,000,003,001,001,000,000 (all except AC fail
> > =default even though some will never happen)
> > [371]0000
> > [380]1=ON rest OFF
> > [381]-end off,FFFF
> >
> > AGAIN, MUCH THANKS FOR YOUR FEEDBACK.I AM LEARNING A LOT.
> >
>
>