Re: DSC-Cross Zone Police Code Alarm PROBLEM

["Doug L" <vssdoug@xxxxxxx>]

Assuming that you have contact ID programmmed in both locations in 360, you
have 361 option 1 as on ,that you don't have the system partitioned and you
don't have transmission delay enabled in the zone attributes, then I would
try changing section 363 option 1 and 368 option 1 to on, if that doesn't
help then you could try  another code in section 328 instead of 4A such as
33 just to see if the CS is mishandling 4A

Doug L

--

<oldmantrying@xxxxxxxxxxx> wrote in message
news:k7al929n39tfr5krfj2p89pf05hprk3639@xxxxxxxxxx
> Maybe some of your feedback may be referring to later VERSIONS of the
> DSC 832 than I have. I have an installation manual & programming
> worksheets booklet that are VERSION 2.0. I assume, perhaps
> incorrectly, that I have a Version 2.0 board. Board was purchased NEW.
>
> The only place I can program  for Cross Zone is [328] Miscellaneous
> Alarm Reporting Codes. I do not see any opportunity to program
> anything about which ZONES or TIME between violations that constitute
> cross zone. I have read in later Versions' manuals ( V 3.0 I think)
> that you can program times and perhaps other options.
> For [101]-[132] I only have 8 options per zone.
>
> Maybe there is a  parameter that I have programmed incorrectly.
>
> Here are the ones that MIGHT possibly effect cross zone and my
> programming of these. I think all the parameters associated with cross
> zone are programmed correctly because the central station gets
> everything ELSE correctly.
>
> [328] option 4 & 5 = FF,OPTION 6 of course= 4A
> [001]-[004] Doors=01, Windows=03, Some motions are=06, most are 05
> [320]-[327] doors=34,windows=31, motions=32
> [330]-[338]=FF
> [339]-[348] all except Duress are FF
> [349]-[351] all FF (If I am not home nobody to fix anything)
> [352]-353]=FF
> [360] option 1=on, others=OFF
> [362]-[364]=off
> [365] option 1=on, rest=off
> [366]=all off
> [367] option 1=ON, rest=off
> [367] option 1=on, rest off
> [368]= OFF
> [370] 003,003,003,000,000,003,001,001,000,000 (all except AC fail
> =default even though some will never happen)
> [371]0000
> [380]1=ON rest OFF
> [381]-end off,FFFF
>
> AGAIN, MUCH THANKS FOR YOUR FEEDBACK.I AM LEARNING A LOT.
>