Re: Programming Power632 for ContactID reporting

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

Thats light 3, auto CID is light 7 and I never understood why DSC defaulted
it to off in the first place

"petem" <petem001@xxxxxxxxx> wrote in message
news:FHdDf.9120$rX.135924@xxxxxxxxxxxxxxxxxxxxxx
> Mark that would be true if it would be a sia system,but the OP is talking
> about CID
>
>
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> a écrit dans le message de news:
> xaSdnZOJx-edwEDeRVn-qg@xxxxxxxxxxxxxx
> > Do NOT do it that way, it ends up being a bitch....
> >
> > Go to location 381 and turn light 7 off and it will all send correctly
> >
> > "Brandon" <bmbeck@xxxxxxxxx> wrote in message
> > news:1138561549.500129.74830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >> Hi Jim,
> >>
> >> Thanks for the quick reply.  In looking through the installer manual it
> >> seems like an A2 report code is an indication of "Fail to Report In"
> >> which is under the Medical Alarm section.  I'm getting this from page
> >> 44 in "Appendix A: Reporting Codes" in a table called "Table2: Contact
> >> ID Zone Alarm/Restoral Event Codes (as per ADEMCO)".  Is this what you
> >> intended or am I misinterpreting something?
> >>
> >> Assuming I'm just misinterpreting something and I do need to place an
> >> A2 report code into each code I wish to get reports on could you give
> >> me an example of how I would do that?  I see in that same Appendix that
> >> section [320] is the Zone Alarms reporting code that is sent when a
> >> zone goes into alarm.  Am I just looking at punching in "*8 <installer
> >> code> 302 *12" where the *1 is the HEX A.  Or am I missing something?
> >>
> >> Thanks again for your help,
> >> Brandon
> >>
> >
> >
>
>