Re: Programming Power632 for ContactID reporting

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

Do NOT do it that way, it ends up being a bitch....

Go to location 381 and turn light 7 off and it will all send correctly

"Brandon" <bmbeck@xxxxxxxxx> wrote in message
news:1138561549.500129.74830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hi Jim,
>
> Thanks for the quick reply.  In looking through the installer manual it
> seems like an A2 report code is an indication of "Fail to Report In"
> which is under the Medical Alarm section.  I'm getting this from page
> 44 in "Appendix A: Reporting Codes" in a table called "Table2: Contact
> ID Zone Alarm/Restoral Event Codes (as per ADEMCO)".  Is this what you
> intended or am I misinterpreting something?
>
> Assuming I'm just misinterpreting something and I do need to place an
> A2 report code into each code I wish to get reports on could you give
> me an example of how I would do that?  I see in that same Appendix that
> section [320] is the Zone Alarms reporting code that is sent when a
> zone goes into alarm.  Am I just looking at punching in "*8 <installer
> code> 302 *12" where the *1 is the HEX A.  Or am I missing something?
>
> Thanks again for your help,
> Brandon
>