Re: Programming Power632 for ContactID reporting

["petem" <petem001@xxxxxxxxx>]

Mark that would be true if it would be a sia system,but the OP is talking
about CID


"Mark Leuck" <m..leuck@xxxxxxxxxxx> a écrit dans le message de news:
xaSdnZOJx-edwEDeRVn-qg@xxxxxxxxxxxxxx
> Do NOT do it that way, it ends up being a bitch....
>
> Go to location 381 and turn light 7 off and it will all send correctly
>
> "Brandon" <bmbeck@xxxxxxxxx> wrote in message
> news:1138561549.500129.74830@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Hi Jim,
>>
>> Thanks for the quick reply.  In looking through the installer manual it
>> seems like an A2 report code is an indication of "Fail to Report In"
>> which is under the Medical Alarm section.  I'm getting this from page
>> 44 in "Appendix A: Reporting Codes" in a table called "Table2: Contact
>> ID Zone Alarm/Restoral Event Codes (as per ADEMCO)".  Is this what you
>> intended or am I misinterpreting something?
>>
>> Assuming I'm just misinterpreting something and I do need to place an
>> A2 report code into each code I wish to get reports on could you give
>> me an example of how I would do that?  I see in that same Appendix that
>> section [320] is the Zone Alarms reporting code that is sent when a
>> zone goes into alarm.  Am I just looking at punching in "*8 <installer
>> code> 302 *12" where the *1 is the HEX A.  Or am I missing something?
>>
>> Thanks again for your help,
>> Brandon
>>
>
>