Re: CP-01

["Mark Leuck" <m..leuck@xxxxxxxxxxx>]

"Don" <don@xxxxxx> wrote in message
news:1l1ih.3741$AY1.2803@xxxxxxxxxxxxxxxxxxxxxxxxx
>
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:hpKdnfCdU-q57hXYnZ2dnUVZ_tCtnZ2d@xxxxxxxxxxxxxx
> >
> > "Roland" <roland@xxxxxxxxxxxx> wrote in message
> > news:Q4Whh.23090$GB1.13821@xxxxxxxxxxxxxxxxxxxxxxx
> >> I don't know what he'll say but I was told on burg zones it is set at
30
> >> seconds default and can be lowered to 15 seconds . If set lower than 15
> >> it
> >> defaults back to 30.  No delay on fire or panic or trouble zones.
> >
> > It depends on the panel, Honeywell does allow removing the dialer delay
> > but
> > you have to jump through hoops to do it, DSC has a minimum 15 seconds
that
> > cannot be removed. GE/ITI has always had a built-in dialer delay whether
> > or
> > not you implement it.
> >
> > New versions of the GE/Caddx panels have it minimum 15 seconds.
> >
>
> this can be turned off with NXV2

Regardless of the version, you can turn it off in sensor characteristics
programming however that's as much of a pain in the ass as turning it off in
Honeywell panels, besides the current GE panels will be gone in about a year
and be replaced by panels that do not allow disabling