Re: DSC 832

["alarman" <alarman2000@xxxxxxxxx>]

Aiiiiiiiiieeeeeeeeeeeeee!
js
"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:457645b6$0$25776$815e3792@xxxxxxxxxxxxxxxxx
> run away.
>
>
>
>
>
>
> "gipdc" <gipdc@xxxxxxx> wrote in message
> news:1165375892.608429.202530@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> I have not used any of the resistor supplied.  I don't know how to
> install resistors.  I only have 1 motion sensor.  I assumed the 8 on
> the keypad after entering the 'supervision' represented the keypad
> location... I must be wrong.  I don't know what is on zone 8.   I don't
> know how to program the motion for a specific zone.  I am stumped... :(
>
> Robert L Bass wrote:
>> > What zone type did you program the motion for?
>> > What is on zone 8?
>> > If zone 8 is empty, close the zone at the panel.
>> > If zone 8 is the motion, then you have the incorrect zone type
>> > programmed. It should be type 5
>>
>> Also, did you use an EOL resistor and if so, how did you wire it into the
>> sensing circuit (zone)?
>>
>> --
>>
>> Regards,
>> Robert L Bass
>>
>> =============================>
>> Bass Home Electronics
>> 941-866-1100
>> 4883 Fallcrest Circle
>> Sarasota · Florida · 34233
>> http://www.bassburglaralarms.com
>> =============================>
>
>