Re: DSC 832

["gipdc" <gipdc@xxxxxxx>]

I have not used any of the resistor supplied.  I don't know how to
install resistors.  I only have 1 motion sensor.  I assumed the 8 on
the keypad after entering the 'supervision' represented the keypad
location... I must be wrong.  I don't know what is on zone 8.   I don't
know how to program the motion for a specific zone.  I am stumped... :(

Robert L Bass wrote:
> > What zone type did you program the motion for?
> > What is on zone 8?
> > If zone 8 is empty, close the zone at the panel.
> > If zone 8 is the motion, then you have the incorrect zone type programm=
ed. It should be type 5
>
> Also, did you use an EOL resistor and if so, how did you wire it into the=
 sensing circuit (zone)?
>
> --
>
> Regards,
> Robert L Bass
>
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D>
> Bass Home Electronics
> 941-866-1100
> 4883 Fallcrest Circle
> Sarasota =B7 Florida =B7 34233
> http://www.bassburglaralarms.com
> =3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=
=3D=3D=3D=3D=3D>