Re: DSC 832

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

What zone type did you program the motion for?
What is on zone 8?
If zone 8 is empty, close the zone at the panel.
If zone 8 is the motion, then you have the incorrect zone type programmed.
It should be type 5

Jim Rojas



"gipdc" <gipdc@xxxxxxx> wrote in message
news:1165351283.745761.176860@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hi, I have just finished wiring DSC 832 basis system together.  There
> is only one PIR sensor.  I am having trouble activating the system..
> i.e., arming it.  I think that my wiring installation is correct..  I
> am unable to get the system to be in the ready state to arm the system.
> I did the supervision part of the programming ... showing 8 on the LCD.
> This is the location of the Keypad.  I don't know if it is sensing the
> PIR sensor.   Any help would be great.
>