Re: DSC 832

["Jim Rojas" <jrojas@xxxxxxxxxxxx>]

If your other zones are working, chances are the resistor option has been
turned off. Go to the panel, and take a look at the zone 8 input terminals.
It is marked Z8 & C. If there is no wire on Z8, place a jumper across Z8 &
C. That should clear the zone.

If all else fails, give me a call anytime, and I will help you in better
detail. I am available on weekends as well.

Jim Rojas
(813) 884-6335




"gipdc" <gipdc@xxxxxxx> wrote in message
news:1165375892.608429.202530@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I have not used any of the resistor supplied.  I don't know how to
install resistors.  I only have 1 motion sensor.  I assumed the 8 on
the keypad after entering the 'supervision' represented the keypad
location... I must be wrong.  I don't know what is on zone 8.   I don't
know how to program the motion for a specific zone.  I am stumped... :(

Robert L Bass wrote:
> > What zone type did you program the motion for?
> > What is on zone 8?
> > If zone 8 is empty, close the zone at the panel.
> > If zone 8 is the motion, then you have the incorrect zone type
> > programmed. It should be type 5
>
> Also, did you use an EOL resistor and if so, how did you wire it into the
> sensing circuit (zone)?
>
> --
>
> Regards,
> Robert L Bass
>
> =============================>
> Bass Home Electronics
> 941-866-1100
> 4883 Fallcrest Circle
> Sarasota · Florida · 34233
> http://www.bassburglaralarms.com
> =============================>