Re: Paragon Plus

[Chris <no@xxxxxxxxxx>]

"BIG NIGE" <no.way@xxxxxxxxxxxxxxxx> wrote in
news:VCoqe.10049$m4.9231@xxxxxxxxxxxxxxxxxxxx:

> To Default ALL the Programming
> I will assume that you have located the main control unit and are not
> working from a remote keypad
>
> Remove mains power (assuming that the battery in the panel is ok then
> the outside siren should NOT sound)
>
> Loose small pozi screw at top of main control unit  (do not remove
> fully only unscrew enough to allow top of front to swing forward ) you
> may need to get your fingernails in as they can be a bit tight.  AS
> you swing it forward it will become unattatched at the bottom (BE
> CAREFUL THAT THE BATTERY DOES NOT FALL OUT AS YOU DO THIS) It should
> be held in place with a strap but they often are not.
>
> Disconnect the battery from the connectors  (at this point the
> External SIREN should sound)
>
> Hold in buttons 1 & 4 and re-connect battery &/OR mains you should now
> have default codes AND programming
>
>
> "BIG NIGE" <no.way@xxxxxxxxxxxxxxxx> wrote in message
> news:Xpoqe.19529$iy2.1468@xxxxxxxxxxxxxxxxxxxxxxx
>> I dont have a PDF of the manual  (which includes instructions on how
>> to default the programming
>>
>> I want to avoid defaulting the programming if possible atm so that we
>> can check on the programming already installed.
>>
>> To default the codes you have to default ALL programming.
>>
>> Has the Back page of your engineers manual been filled in with the
>> zones, how they are programmed and the timers etc
>>
>> "Chris" <no@xxxxxxxxxx> wrote in message
>> news:Lboqe.18263$%21.7897@xxxxxxxxxxxxxxxxxxxxxxx
>> > >> You say that you know the limited user code but not the master
>> > >> code or the engineers code
>> > >> I will assume that it is 5678 that you are using because the
>> > >> original installer dropped a clanger and didnt change it.
>> > >> as you are aware the original master code was 1234.
>> > >>
>> > >> As they didnt seem to know what they were doing we will check to
>> > >> see if
>> > > the
>> > >> original engineers code is still in rather than defaulting the
>> > >> whole
>> > > system
>> > >> straight off.
>> >
>> > The limted user code i have is not the default 5678.  I really
>> > think i need the installers manual and the method to default the
>> > system, If nto can you recommend anyone local to me who can come
>> > out and sort it for
> me?
>> >
>> > Preferably for the price of a few pints!! :-)
>>
>>
>
>

Ok i'll give it a try but how do i then re-programme the different PIR's
to make the entry/exit zones, immediate activation etc.  Or what is the
default programme set to?

If you could scan the manual or something i will give you an e-mail
address to send it to.

Thanks again

Chris