Re: Paragon Plus

["BIG NIGE" <no.way@xxxxxxxxxxxxxxxx>]

To Default ALL the Programming
I will assume that you have located the main control unit and are not
working from a remote keypad

Remove mains power (assuming that the battery in the panel is ok then the
outside siren should NOT sound)

Loose small pozi screw at top of main control unit  (do not remove fully
only unscrew enough to allow top of front to swing forward ) you may need to
get your fingernails in as they can be a bit tight.  AS you swing it forward
it will become unattatched at the bottom (BE CAREFUL THAT THE BATTERY DOES
NOT FALL OUT AS YOU DO THIS) It should be held in place with a strap but
they often are not.

Disconnect the battery from the connectors  (at this point the External
SIREN should sound)

Hold in buttons 1 & 4 and re-connect battery &/OR mains you should now have
default codes AND programming


"BIG NIGE" <no.way@xxxxxxxxxxxxxxxx> wrote in message
news:Xpoqe.19529$iy2.1468@xxxxxxxxxxxxxxxxxxxxxxx
> I dont have a PDF of the manual  (which includes instructions on how to
> default the programming
>
> I want to avoid defaulting the programming if possible atm so that we can
> check on the programming already installed.
>
> To default the codes you have to default ALL programming.
>
> Has the Back page of your engineers manual been filled in with the zones,
> how they are programmed and the timers etc
>
> "Chris" <no@xxxxxxxxxx> wrote in message
> news:Lboqe.18263$%21.7897@xxxxxxxxxxxxxxxxxxxxxxx
> > >> You say that you know the limited user code but not the master code
> > >> or the engineers code
> > >> I will assume that it is 5678 that you are using because the original
> > >> installer dropped a clanger and didnt change it.
> > >> as you are aware the original master code was 1234.
> > >>
> > >> As they didnt seem to know what they were doing we will check to see
> > >> if
> > > the
> > >> original engineers code is still in rather than defaulting the whole
> > > system
> > >> straight off.
> >
> > The limted user code i have is not the default 5678.  I really think i
> > need the installers manual and the method to default the system, If nto
> > can you recommend anyone local to me who can come out and sort it for
me?
> >
> > Preferably for the price of a few pints!! :-)
>
>