Re: Programming problem on Vista 20P

["Ranger" <hd_ranger@xxxxxxxxxxx>]

Mike,
        Sounds like you have the receiver in the keypad disabled.  The 5804
will work with the keypad (local) whether the receiver is enabled or
disabled. Since you originally programmed the remote into the keypad, it
works. But when you went into *58, and added a wireless zone for the panic,
the panel, seeing its first wireless zone, is now looking for a receiver.
You said you disabled your new zones, but a disabled wireless zone is still
a wireless zone.  It has to be deleted to keep the panel from looking for a
receiver.
        (If this was not the first wireless zone in the panel, ignore the
above.)

        I never tried programming the same remote into the panel and an RF
keypad; that could be an issue as well....

        Try deleting the 5804 from the keypad, and delete the new zones from
the panel (using *56 menu.)  Come out of programming and see if you still
get a check 100.  If not, great.  Then if you want to program the 5804 to
the panel, make sure the receiver is enabled in the keypad.  Otherwise just
program the remote to the keypad as you did before, but make one button your
panic.

Hopefully helpful,
Rick C.

 "Mike" <reply@xxxxxxxxxxxxxx> wrote in message
news:qrudnRveIZpSovHfRVn-2Q@xxxxxxxxxxxxxx
> I tried setting the Receiver address on the 5160RF to 00 (was 01) and i
> still get the same error.
> This all happened as i first mentioned after going into the 6160 and
trying
> to set up the keyfob buttons.
>
> The covers are on both keypads and i dont remember seeing or reading
> anything about tamper switches.
> I also didnt move or do anything with either keypad before this occured.
> Please dont make me reset to factory defaults.
> I guess if i have to, its only 3 zones and the keyfob programming. If you
> guys have any other ideas, i wont be hopping on this again for a couple
> days.
> Thanks
>
>
>
> "Mark Leuck" <m..leuck@xxxxxxxxxxx> wrote in message
> news:EZidndOkg8gBtfHfRVn-vw@xxxxxxxxxxxxxx
> > That keypad may not have a tamper switch, Honeywell took them out a
while
> > back
> >
> > "RJD314" <rdvorak314@xxxxxxx> wrote in message
> > news:1114382255.239870.85570@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> >> The 6150RF keypad default wireless receceiver address is 00.  Make sure
> >> the keypad is seated correctly on the backplate.  If the tamper switch
> >> is tripped, the 20p will display a "Check 100 RF Receiver".  Try
> >> holding the tamper manually for a couple of minutes to see if the
> >> "Check 100 RF Receiver" restores.
> >>
> >
> >
>
>