Programming problem on Vista 20P

["Mike" <reply@xxxxxxxxxxxxxx>]

I have a 20P with 2 keypads. A 6160 and a 6150RF.
Had everythng programmed and seemingly working fine on the bench. (good
advice guys thanks)
I initially programmed the 5804 Keyfob via the 6150RF keypad. It worked well
although i couldnt figure out how to change one of the buttons to be used as
a panic button.
I decided in my infinite greeny wisdom to try reprogramming the keyfob from
the 6160 keypad using the #3 template via *58.
After doing this i now get the error "Check 100 RF Receiver" according to
the info in the install and setup guide this indicates that "communication
between control and a zone expander or wireless receiver is interupted.
Where xx is the device address." So i know that 01 is the device address for
the 6150RF, so im not sure where to look in the programming to delete the
mistake i just made by going through the *58 Wireless Key Programming
Templates procedure.
I tried going back and disabling all the zones that were made active by
this, and im still getting the same error.
Funy thing is the 6150RF Keypad is still working, and the keyfob still works
as it was when i first programmed it from the 6150RF.
Somewhere i must have entered in device 00 as the device number for the
6150RF when i was trying to reprogramm the keyfob from the 6160.
Any Vista 20P gurus care to shed some light on this mess?

Thanks