Re: BSR X-10 Ultrasonic Command Console

["BruceR" <razrbruce@xxxxxxxxxxxxxxx>]

Look in that hole again. I'm holding one in my hand and can see a
phillips head screw in there. You'll need a thin shafted screwdriver to
get to it but that's how you'll get it open.  I have a bunch of these
purchased from DAK in 1984 and they still work (along with the
Ultrasonic remotes!).

 oldtimer@xxxxxxxxx wrote:
> Remember these? I'll bet a number of you do. I have just found one
> from my early days as an X-10 independent rep in the mid 80s. It still
> works but is gummed up from our wonderfully polluted New York air and
> what appears to be tape adhesive residue. I'd like to disassemble the
> case and clean it thoroughly before pressing it into service again.
>
> There is a hole on the underside of the case however it seems to be
> the underside of an internal post, in any case it is not a screw hole.
> I removed all four rubber feet thinking there might be screws under
> them and again, no luck. With the newer battery powered units I just
> remove the batteries and run them through the dishwasher as I do my
> mice and keyboards making certain they are completely dry before
> connecting again. This however plugs in to 110 power and I'm less
> inclined to try the same successful approach with it.
>
> Any advice on taking this puppy apart?
>
> Thanks.