Re: Ocelot

[nobody@xxxxxxxxxxxx (Dave Houston)]

Do you have any way to send X-10 independent of the Ocelot?

What are the model numbers of the plug-in and hard-wire units?

"Gargamil" <wooble@xxxxxxxxxxx> wrote:

>The non responsive units are all the plug in modules - irrespective of where
>they are in the house.  Yes the computer module triggers the plug in modules
>every time.
>
>Hello, Dave!
>You wrote  on Thu, 18 Aug 2005 10:53:35 GMT:
>
> DH> Are the non-responsive units all on one circuit or on both?
>
> DH> Do you have any way to send X-10 independent of the Ocelot?
>
> DH> "Gargamil" <wooble@xxxxxxxxxxx> wrote:
>
> ??>> Hello, Dave!
> ??>>
> ??>>    Single phase.  Two power circuits - ie two fuses at the box.
> ??>>
> ??>> You wrote  on Wed, 17 Aug 2005 10:16:08 GMT:
> ??>>
> DH>>> Do you have single or multi-phase power?
> ??>>
> DH>>> "Gargamil" <wooble@xxxxxxxxxxx> wrote:
> ??>>
> ??>>>> Hello, All!
> ??>>>>
> ??>>>>    After much stuffing around I finally got my Ocelot programmed and
> ??>>>> happening.  One problem, whilst the Ocelot sees incoming X10, the
> ??>>>> X10 it sends is not picked up by any of the plug in units.  All the
> ??>>>> hard wired units work fine.  Any clues.
> ??>>>>
> ??>>>>    I've even gone so far as to plug the XM10 into the same power
> ??>>>> point as a lamp.  Nothing.  Can turn it on and off with X10.  The
> ??>>>> Ocelot sees those signals but sending X10 to the plug in modules
> ??>>>> result in 0.
> ??>>>>
> ??>>>> g
> ??>>>>
> ??>> With best regards, Gargamil.  E-mail: wooble@xxxxxxxxxxx
> ??>>
>
>With best regards, Gargamil.  E-mail: wooble@xxxxxxxxxxx
>