Re: Ocelot

[nobody@xxxxxxxxxxxx (Dave Houston)]

What plug-in units do you have? What hard wired units?

Are the non-responsive units all on one circuit or on both?

Do you have any way to send X-10 independent of the Ocelot?

"Gargamil" <wooble@xxxxxxxxxxx> wrote:

>Hello, Dave!
>
>    Single phase.  Two power circuits - ie two fuses at the box.
>
>You wrote  on Wed, 17 Aug 2005 10:16:08 GMT:
>
> DH> Do you have single or multi-phase power?
>
> DH> "Gargamil" <wooble@xxxxxxxxxxx> wrote:
>
> ??>> Hello, All!
> ??>>
> ??>>    After much stuffing around I finally got my Ocelot programmed and
> ??>> happening.  One problem, whilst the Ocelot sees incoming X10, the X10
> ??>> it sends is not picked up by any of the plug in units.  All the hard
> ??>> wired units work fine.  Any clues.
> ??>>
> ??>>    I've even gone so far as to plug the XM10 into the same power point
> ??>> as a lamp.  Nothing.  Can turn it on and off with X10.  The Ocelot
> ??>> sees those signals but sending X10 to the plug in modules result in 0.
> ??>>
> ??>> g
> ??>>
>
>With best regards, Gargamil.  E-mail: wooble@xxxxxxxxxxx
>