Re: Scantronic/Arrowhead ScanPro downloader software

[Innerpicked <spongebob987654321@xxxxxxxx>]

On Thursday, December 10, 2020 at 2:18:18 PM UTC-8, herber...@xxxxxxxxx wro=
te:
> On Thursday, December 10, 2020 at 1:56:28 PM UTC-7, ABLE1 wrote:=20
> > On 12/10/2020 11:55 AM, RTS wrote:=20
> > > On 12/10/2020 9:54 AM, Bob La Londe wrote:=20
> > >> On 12/9/2020 11:56 PM, Rainbow_Dash_7x wrote:=20
> > >>> Hello, I am looking for the downloader software for a super old=20
> > >>> panel. It is a Scantronic SC800 with a SK1l keypad. I have seen the=
se=20
> > >>> branded as "Arrowhead" as well. The software is listed as the=20
> > >>> "ScanPro downloader software" in the programming manual. There is=
=20
> > >>> very little info on this panel out there, but I was hoping someone=
=20
> > >>> would have or know where I can get that software. I can't find any=
=20
> > >>> record of it's existence except it being mentioned in the programmi=
ng=20
> > >>> manual quite a bit. Let me know if you know anything about this=20
> > >>> software, or where I could find it. It would be super useful for=20
> > >>> programming this panel, as I'm sure most of you know that keypad=20
> > >>> programming is a pain sometimes.=20
> > >>>=20
> > >>> Thanks!=20
> > >>>=20
> > >>=20
> > >>=20
> > >> Didn't those use an EPROM burner?=20
> > >>=20
> > > believe your right Bob...=20
> > >=20
> > And if I dig really deep enough in my storage locker I actually=20
> > have 2 or 3 EEPROM chip burners. Don't know the model numbers=20
> > but they are there somewhere.=20
> >=20
> > Les
> The SC800 actually can be programmed from the keypad, downloader, or by c=
opying the EEPROM from another panel. The chip programming isn't permanent =
and can be changed repeatedly from the panel. I just want to find the softw=
are, I'll leave a link to the programming manual I am using.=20
>=20
> http://www.ebastlirna.cz/ddump/files/Manualy/EZS_hlasice_ustredny/SC1600_=
Installation.pdf


Probably made for Windows 98, but here it is. https://static.interlogix.com=
/library/scanpro4.zip