Re: Scantronic/Arrowhead ScanPro downloader software

[ABLE1 <somewhere@xxxxxxxxxxx>]

On 12/10/2020 11:55 AM, RTS wrote:
> On 12/10/2020 9:54 AM, Bob La Londe wrote:
>> On 12/9/2020 11:56 PM, Rainbow_Dash_7x wrote:
>>> Hello, I am looking for the downloader software for a super old
>>> panel. It is a Scantronic SC800 with a SK1l keypad. I have seen these
>>> branded as "Arrowhead" as well. The software is listed as the
>>> "ScanPro downloader software" in the programming manual. There is
>>> very little info on this panel out there, but I was hoping someone
>>> would have or know where I can get that software. I can't find any
>>> record of it's existence except it being mentioned in the programming
>>> manual quite a bit. Let me know if you know anything about this
>>> software, or where I could find it. It would be super useful for
>>> programming this panel, as I'm sure most of you know that keypad
>>> programming is a pain sometimes.
>>>
>>> Thanks!
>>>
>>
>>
>> Didn't those use an EPROM burner?
>>
>  Â  believe your right Bob...
>


And if I dig really deep enough in my storage locker I actually
have 2 or 3 EEPROM chip burners.  Don't know the model numbers
but they are there somewhere.

Les