Re: Scantronic/Arrowhead ScanPro downloader software

[Bob La Londe <none@none.com99>]

On 12/9/2020 11:56 PM, Rainbow_Dash_7x wrote:
> Hello, I am looking for the downloader software for a super old panel. It is a Scantronic SC800 with a SK1l keypad. I have seen these branded as "Arrowhead" as well. The software is listed as the "ScanPro downloader software" in the programming manual. There is very little info on this panel out there, but I was hoping someone would have or know where I can get that software. I can't find any record of it's existence except it being mentioned in the programming manual quite a bit. Let me know if you know anything about this software, or where I could find it. It would be super useful for programming this panel, as I'm sure most of you know that keypad programming is a pain sometimes.
>
> Thanks!
>


Didn't those use an EPROM burner?

--
This email has been checked for viruses by AVG.
https://www.avg.com