Re: GEMINI P3200 KEYPAD MESSAGE

["Bob La Londe" <none@xxxxxxxxxx>]

<proguardsec@xxxxxxxxx> wrote in message
news:1c6a703a-ff3a-4fd2-9ec5-f8033e397362@xxxxxxxxxxxxxxxxxxx
> Τη Î?Ï?Ï?ιακή, 9 ΣεÏ?Ï?εμβÏ?ίοÏ? 2012 2:16:15 μ.μ. UTC+3, ο Ï?Ï?ήÏ?Ï?ηÏ? Frank Kurz
> έγÏ?αÏ?ε:
>> On 08/09/2012 10:07 PM, proguard wrote:
>>
>> > On 9 οÎ?½οÎ?½οÎ?½οÎ?½, 02:33, G. Morgan <sealte...@xxxxxxxxxxxxxxxxx>
>> > wrote:
>>
>> >> proguard...@xxxxxxxxx Wrote:
>>
>> >>
>>
>> >>> I get "enter your code to access area" at GEM-DXRP1 keypad connecting
>> >>> to a Gemini P3200. Even master security code want work. Any idea?
>>
>> >>> Thank you!
>>
>> >>
>>
>> >> If you are trying to get into programming, is it KP #1 ?  Programming
>>
>> >> has to be done on that one.
>>
>> >>
>>
>> >> Master code wont disarm IIRC if that's what you're trying to do.
>>
>> >>
>>
>> >> If the system was working and you just came to service, power-cycle it
>>
>> >> first - that fixes everything on those POS panels. <g>
>>
>> >>
>>
>> >> What *are* you trying to do?
>>
>> >
>>
>> > I made a cold start to the panel and after that i made doownload.
>>
>> > Everything was ok.
>>
>> > I was downloading the panel which was in disarm mode and after ending
>>
>> > download this message came up.
>>
>> > I took the panel on the bench in order to find out what happens.
>>
>> > The keypad is in address 01. Of course i power cycle it but after the
>>
>> > panel boot up this msg came up:
>>
>> > "Enter our code to access area" I used master security code, dealer
>>
>> > code, user code 1, user code 2, but still the same.
>>
>> > "Invalid access code, try again" It's the first time i saw this msg...
>>
>> >
>>
>>
>>
>> I'm not all that familiar with the Napco products, but it sounds to me
>>
>> like you've programmed the keypad as a global partition and it's not
>>
>> actually "parked" in the one you want to arm.  Try entering partition 1
>>
>> from the keypad and then it should work normally.  When you download it
>>
>> again (as I'm sure you will), try assigning it to partition 1 and I
>>
>> think you'll avoid getting this message.
>>
>>
>>
>>
>>
>> --
>>
>> Fire Protection Technicians Network
>>
>> www.firetechs.net
>
> Its the most strange situation. The panel denies to answer the incoming
> call for dl and always get the message "enter your code to access area"
> !!!
> i cannot get into programming even with master security code!

Are you using the code on the sticker?  If so you might try a spare PROM and
the code that comes with it.