Re: PTC protected dual battery harness

["Mark Leuck" <m..leuck@xxxxxxxxx>]

"Roland Moore" <nospam@xxxxxxxxxx> wrote in message
news:47ef3a64$0$22798$4c368faf@xxxxxxxxxxxxxxxxx
> I think I said barely an AMP. As in less than an amp. The 700ma is the
> threshold in the manual for having to add a booster. When you meter it
with
> a load it can get up to nearly an AMP of output before factory smoke
becomes
> a concern. I wouldn't recommend doing it. In fact I would recommend any
DSC
> panel if there is a substantial load present.

That sounds like a Bass response and it sounds like you have no problems
with grossly overloading panels








>
> "Mark Leuck" <m..leuck@xxxxxxxxx> wrote in message
> news:47ef0a04$0$30698$4c368faf@xxxxxxxxxxxxxxxxx
> >
> > "Just Looking" <nospam@xxxxxxxxxx> wrote in message
> > news:47eedeac$0$17363$4c368faf@xxxxxxxxxxxxxxxxx
> > > News to DSC? I don't think so.
> > > It is right in their installation manual.
> > >
> > > (From the old Power Series manual)
> > > Auxiliary Power Terminals - AUX+ and AUXThese
> > > terminals provide up to 550 mA of additional current at
> > > 12 VDC for devices requiring power. Connect the positive side
> > > of any device requiring power to the AUX+ terminal, the negative
> > > side to AUX- (ground). The AUX output is protected. This
> > > means that if too much current is drawn from these terminals
> > > (such as a wiring short), the panel will temporarily shut off the
> > > output until the problem is corrected.
> > >
> > > (From the new Power Series manual)
> > > The control panel can provide a maximum of 700mA of current for
modules,
> > > powered detectors, relays, LED's etc.
> >
> > Last I checked 550mA and 700mA wasn't 1A
> >
> >
> > >
> > >
> > > "Mark Leuck" <m..leuck@xxxxxxxxx> wrote in message
> > > news:47ee98ce$0$1091$4c368faf@xxxxxxxxxxxxxxxxx
> > > >
> > > > "Roland Moore" <nospam@xxxxxxxxxx> wrote in message
> > > > news:47edde8d$0$22822$4c368faf@xxxxxxxxxxxxxxxxx
> > > > > Come on man. It's a DSC panel. They just barely have their power
out
> > up
> > > to
> > > > 1
> > > > > AMP for the first time in the new "Power" series panels.
> > > >
> > > > That'll be news to DSC
> > > >
> > > >
> > >
> > >
> >
> >
>
>