Re: Cannot active program mode on Napco MA3000 ...

["Mark Leuck" <m..leuck@xxxxxxxxx>]

"dyz" <spambegone@xxxxxxxxxxxxx> wrote in message
news:47a13753$0$6324$607ed4bc@xxxxxxxxx
> Not sure about the age of the system,  I know the previous owner built the
> detached
> garage about 15 years ago and ran some sort of home business in there. I
> guess the
> system was installed then in order to provide two zone protection.
>
> The system works just fine other than not allowing me going into the
program
> mode.
> I followed exactly what the manual says about entering program mode, but
it
> simply
> does not work. This is what I've being doing when trying to enter program
> mode:
>     1) enter master code then press [function] button;
>     2) press [bypass] button repeatedly;
>     3) when "ACTIVE PROGRAM" is displayed, press [on/off] button
>
> The display immediately goes back to SYSTEM READY after 3). Is this a sign
> that
> the system is locking me out?
>
> Thanks!
>
> DYZ

It scares me to think if you have this much trouble what you'd do if you
actually did get into programming