Re: Problem with Battery Recharging in Lynx-R

["Jack" <jack@xxxxxxxxxxxxx>]

"tourman" <robercampbell@xxxxxxxxx> wrote in message
news:1190590668.803834.208860@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> On Sep 23, 7:23 pm, "Jack" <j...@xxxxxxxxxxxxx> wrote:
>> "Crash Gordon" <webmas...@xxxxxxxxxxxxxxxxxxxxx> wrote in message
>>
>> news:46f6f475$0$502$815e3792@xxxxxxxxxxxxxxxxx> did you do a code+off,
>> code+off?
>>
>> Crash I did Code + 5 waited 10 seconds then Code + Off. That's what the
>> manual says.
>
> RHC: It's a long shot, and I don't know the idiocycracies of this
> model, but did you check the battery connections. Use a pencil eraser
> to clean each of the contacts to see if high resistance is causing the
> problem. I've seen it with conventional alarms.....
>

tourman, this begs the question how does the battery pack get charged? There
is no wire that has to be connected. I just slide the old battery drawer out
and slide the new drawer in its place. I then put the screw into the hole at
the bottom of the drawer and screw it back in. I can't see where the battery
draws its current. Does anyone know how the battery get's its current from
the panel?

I also tried Crash's suggestion of Code + Off , Code + Off without any
change to the status quo.