Re: Firewolf 4-wire Napco 816 gives E41

[Mark <sp@xxxxxx>]

Total nerd wrote:
> Okay, now I'm totally stumped.
> I moved it to Zone 8 with the same problem.  I ran a new set of wires
> out in the open across the floor just to make sure I didn't pinch it
> anyware, same thing.  I installed a new "red-red-red" resistor, same
> thing.  I took out the resistor and labeled the zone as "no eol" but
> same thing.  I even tested the thing with a magnet -- it turned red,
> meaning it's working, but of course the panel ignored it.
> Now I'm just out of ideas?  I have the 12v power across power just
> like the manual -- plug #6 and the one directly next to zone 8, and
> certainly it's powered up.  I have it connected to zone 8 and the EOL
> is inline by plugging it into the smoke at the NO connection, then
> plugging the other end onto the yellow wire,

hehehehahaha



which goes back to the
> panel of course, along with the green wire next to it at the adjacent
> terminal.  I even tried swapping them.
> Any ideas? ... maybe without getting too angry about semantics ...?  =)
>