[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Firewolf 4-wire Napco 816 gives E41
7 or 8
yes smokes are open devices
if they're 4wire make sure you do the supervision relay correctly
"Total nerd" <geekboy0001@xxxxxxxxx> wrote in message
news:1188778279.619503.10750@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
| Thanks for your reply...
| I have the EOL as shown in the installation manual. The detector is
| actually on zone 3 and that zone is marked as a Fire zone in the
| windows loader software. Should I only use zone 7 or 8 for this, even
| though it's a 4-fire?
| Speaking of correct installations, all I do to verify that a firewolf
| smoke detector is working is to hold a magnet to the Test spot. The
| panel goes off with a fire alarm and the Firewolf shows red LEDs
| instead of green. That's typically what I do to my own system... I
| haven't tried that in this installation obviously because I'm getting
| this E41 error.
| This is a normally open fire detector, right? Does anything special
| have to be done about that? Maybe I should just move it to zone 7.
| thanks.
|
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home