[Message Prev][Message Next][Thread Prev][Thread Next][Message Index][Thread Index]
Re: Firewolf 4-wire Napco 816 gives E41
Thanks for your reply...
I have the EOL as shown in the installation manual. The detector is
actually on zone 3 and that zone is marked as a Fire zone in the
windows loader software. Should I only use zone 7 or 8 for this, even
though it's a 4-fire?
Speaking of correct installations, all I do to verify that a firewolf
smoke detector is working is to hold a magnet to the Test spot. The
panel goes off with a fire alarm and the Firewolf shows red LEDs
instead of green. That's typically what I do to my own system... I
haven't tried that in this installation obviously because I'm getting
this E41 error.
This is a normally open fire detector, right? Does anything special
have to be done about that? Maybe I should just move it to zone 7.
thanks.
alt.security.alarms Main Index |
alt.security.alarms Thread Index |
alt.security.alarms Home |
Archives Home