Re: Programming a Napco GEM-P9600 V9 E-Prom Attn Robert Bass

["Mark Leuck" <m..leuck@xxxxxxxxx>]

I imagine these days GE contracts that out

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:46031c52$0$510$815e3792@xxxxxxxxxxxxxxxxx
> Doesn't GE make refrigerators?
>
>
>
> "secure15" <secure15@xxxxxxxxxxxxx> wrote in message
> news:fpjMh.265$VW7.52@xxxxxxxxxxxxxxx
> | And GE Concord V4 CAN'T DO IT AT ALL!
> |
> | Crash Gordon wrote:
> | > Napco needs a chip to do that? Sheesh.
> | >
> | >
> | > "secure15" <secure15@xxxxxxxxxxxxx> wrote in message
> | > news:c19Mh.1$iv.0@xxxxxxxxxxxxxxx
> | > | You're also gonna need a version 11E Chip to correct the Daylight
> | > | Savings Time Debacle.
> | > |
> | > |
> | > | Sammi wrote:
> | > | > I tried to get hold of you for quite some time today via the
> phone...I
> | > needed a pci-mini and some other stuff. Since I couldn't get hold of
you
> | > today, I picked one up elsewhere :-(.  Hopefully we cross paths at
some
> | > point :-). I need to setup camera's?so I do need further assistance
> | > regarding purchases.
> | > | >
> | > | > I've got a GEM-P9600.  Went to change the time using the
keypad...in
> | > short, ended up disabling the entire alarm panel. DUH  All zones are
> | > altered, nothing is recognized and the two additional keypads are now
> | > obviously not in the system.  That's what you get when you use the 6
> digit
> | > master code via the keypad?lol
> | > | >
> | > | > ?so now I have to re-program the setup via laptop?almost
impossible
> to
> | > do via the keypad!!
> | > | >
> | > | > We are going to need a few cameras and other items.  I hope to get
> hold
> | > of you within the next day or so for a few additional items.
> | > | >
> | > | > ? Do you have at least an e-mail address, I didn't notice one from
> your
> | > site?
> | > | >
> | > | > Once I connect the laptop?I've never used quickloader for
windows?I
> hope
> | > it is a bit easier to use vs the keypad!!  Do you have any advice?
> Probably
> | > easier to discuss this via the phone?but any pre-help would be great.
> | > | >
> | > | > One thing that I've noticed is that the programming sheets (I've
> | > downloaded a variety of versions obviously) vary a bit.  I'm assuming
> that
> | > the windows based utility is much easier correct?  Since I do not have
> the
> | > pci mini as of yet?I've not looked at the software configuration.  Is
it
> | > intuitive?
> | > | >
> | > | > How do I know which sheets to follow for my setup?  I don't think
> I've
> | > found an older programming sheet that matches my setup.  As mentioned,
> the
> | > E-prom is V9 and the keypads are  two GEM-RP1CA's and 1 GEM-RP1CAe.
> | > | >
> | > | >
> | > | > Looking forward to doing business with you soon!
> | > | >
> | >
> | >
>
>