Re: Programming a Napco GEM-P9600 V9 E-Prom Attn Robert Bass

["Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx>]

Doesn't GE make refrigerators?



"secure15" <secure15@xxxxxxxxxxxxx> wrote in message
news:fpjMh.265$VW7.52@xxxxxxxxxxxxxxx
| And GE Concord V4 CAN'T DO IT AT ALL!
|
| Crash Gordon wrote:
| > Napco needs a chip to do that? Sheesh.
| >
| >
| > "secure15" <secure15@xxxxxxxxxxxxx> wrote in message
| > news:c19Mh.1$iv.0@xxxxxxxxxxxxxxx
| > | You're also gonna need a version 11E Chip to correct the Daylight
| > | Savings Time Debacle.
| > |
| > |
| > | Sammi wrote:
| > | > I tried to get hold of you for quite some time today via the
phone...I
| > needed a pci-mini and some other stuff. Since I couldn't get hold of you
| > today, I picked one up elsewhere :-(.  Hopefully we cross paths at some
| > point :-). I need to setup camera's?so I do need further assistance
| > regarding purchases.
| > | >
| > | > I've got a GEM-P9600.  Went to change the time using the keypad...in
| > short, ended up disabling the entire alarm panel. DUH  All zones are
| > altered, nothing is recognized and the two additional keypads are now
| > obviously not in the system.  That's what you get when you use the 6
digit
| > master code via the keypad?lol
| > | >
| > | > ?so now I have to re-program the setup via laptop?almost impossible
to
| > do via the keypad!!
| > | >
| > | > We are going to need a few cameras and other items.  I hope to get
hold
| > of you within the next day or so for a few additional items.
| > | >
| > | > ? Do you have at least an e-mail address, I didn't notice one from
your
| > site?
| > | >
| > | > Once I connect the laptop?I've never used quickloader for windows?I
hope
| > it is a bit easier to use vs the keypad!!  Do you have any advice?
Probably
| > easier to discuss this via the phone?but any pre-help would be great.
| > | >
| > | > One thing that I've noticed is that the programming sheets (I've
| > downloaded a variety of versions obviously) vary a bit.  I'm assuming
that
| > the windows based utility is much easier correct?  Since I do not have
the
| > pci mini as of yet?I've not looked at the software configuration.  Is it
| > intuitive?
| > | >
| > | > How do I know which sheets to follow for my setup?  I don't think
I've
| > found an older programming sheet that matches my setup.  As mentioned,
the
| > E-prom is V9 and the keypads are  two GEM-RP1CA's and 1 GEM-RP1CAe.
| > | >
| > | >
| > | > Looking forward to doing business with you soon!
| > | >
| >
| >