Re: Programming a Napco GEM-P9600 V9 E-Prom Attn Robert Bass

["Russell Brill" <russwbrill@xxxxxxxxxxxxx>]

One more reason I've given up on them........ I go back when they enter the
21st century...

"Crash Gordon" <webmaster@xxxxxxxxxxxxxxxxxxxxx> wrote in message
news:460143f5$0$490$815e3792@xxxxxxxxxxxxxxxxx
> Napco needs a chip to do that? Sheesh.
>
>
> "secure15" <secure15@xxxxxxxxxxxxx> wrote in message
> news:c19Mh.1$iv.0@xxxxxxxxxxxxxxx
> | You're also gonna need a version 11E Chip to correct the Daylight
> | Savings Time Debacle.
> |
> |
> | Sammi wrote:
> | > I tried to get hold of you for quite some time today via the phone...I
> needed a pci-mini and some other stuff. Since I couldn't get hold of you
> today, I picked one up elsewhere :-(.  Hopefully we cross paths at some
> point :-). I need to setup camera's?so I do need further assistance
> regarding purchases.
> | >
> | > I've got a GEM-P9600.  Went to change the time using the keypad...in
> short, ended up disabling the entire alarm panel. DUH  All zones are
> altered, nothing is recognized and the two additional keypads are now
> obviously not in the system.  That's what you get when you use the 6 digit
> master code via the keypad?lol
> | >
> | > ?so now I have to re-program the setup via laptop?almost impossible to
> do via the keypad!!
> | >
> | > We are going to need a few cameras and other items.  I hope to get
> hold
> of you within the next day or so for a few additional items.
> | >
> | > ? Do you have at least an e-mail address, I didn't notice one from
> your
> site?
> | >
> | > Once I connect the laptop?I've never used quickloader for windows?I
> hope
> it is a bit easier to use vs the keypad!!  Do you have any advice?
> Probably
> easier to discuss this via the phone?but any pre-help would be great.
> | >
> | > One thing that I've noticed is that the programming sheets (I've
> downloaded a variety of versions obviously) vary a bit.  I'm assuming that
> the windows based utility is much easier correct?  Since I do not have the
> pci mini as of yet?I've not looked at the software configuration.  Is it
> intuitive?
> | >
> | > How do I know which sheets to follow for my setup?  I don't think I've
> found an older programming sheet that matches my setup.  As mentioned, the
> E-prom is V9 and the keypads are  two GEM-RP1CA's and 1 GEM-RP1CAe.
> | >
> | >
> | > Looking forward to doing business with you soon!
> | >
>
>